F-2014KB Manual

STEP 1 – OPENING THE SAFE:

1. Install the 4 AA batteries in the Power Override Box. We recommend using high-quality batteries such as Duracell or Energizer.

2. Plug the Power Override Jack to the Power Override Hole.

3. Enter code. Factory default code is: 1-2-3

4. Press the # key.

5. Turn the Knob clockwise (right) and open the door.

NOTE: Remove the batteries from the Power Override Box and install them in the battery box that is located in the back of the safe door.

ENROLLING:

STEP 2 – CHANGING CODE:

1. Open the safe using the code.

2. Press the Setup Button (located in the left side of the back of door, next to the hinges).

3. Now: (while the LED is Yellow)

a. Enter your new code (1-10 digits).

b. Press the # key.

c. The LED will turn off.

d. Your personal code has been changed.

Note: It is highly recommended to leave the door open and test your new code several times before closing the door.

ENROLLING:

STEP 2 – CHANGING CODE:

1. Open the safe using the code.

2. Press the Setup Button (located in the left side of the back of door, next to the hinges).

3. Now: (while the LED is Yellow)

a. Enter your new code (1-10 digits).

b. Press the # key.

c. The LED will turn off.

d. Your personal code has been changed.

Note: It is highly recommended to leave the door open and test your new code several times before closing the door.

TIPS:

1. Don’t use the # key or the * key for your code.

2. Use digits 1 – 0 to enter your code.

3. Use the * key as backspace to clear the last digit.